Better ways to hang a Hennessey Hammock
I love hammock camping. I hate the Hennessey Hammock knot. It is annoying to tie in the first place, and even more annoying to adjust for tension. This article might not make much sense if you don’t use a hammock for camping.
Andre shares in my dislike for the Hennessey Hammock knot. We both took different approaches to fixing this.
His setup is on the left, mine is on the right:
Here are the core pieces of hardware:
On the top is my hardware. It consists of two descending rings tied to a piece of cord. A smaller piece of cord holds a stake.
Andre’s hardware is a cam-lock buckle which is tied to the end of his hammock.
Both start with looping some webbing around the tree, and then back through a loop that is sewn into the end of the webbing. Ignore the buckle on this loop, it isn’t used for anything related to hammocks. I put those on my webbing so that I can dual purpose them as compression straps. This is already a major advantage compared to the Hennessey Tree Hugger method because the webbing can handle any diameter tree (with a max based on the length of your webbing). The Hennessey Tree Huggers tend to work best with trees about 1.5′ in diameter and are too short for larger ones and too long for smaller ones.
I use a knot called a Marlin Spike Hitch to put a spike (this could be a stick or tent stake, I use a small piece of aluminum) into the webbing. The Marlin Spike Hitch is a long name for a very easy to learn knot. Then I hang my loop of cord with the two descending rings from it:
The cord is looped through the descending rings using another fancy sounding knot called the Garda Hitch. It is really a very simple knot too. The advantage here is that you can tension the hammock just by pulling on the loose (free) end of the rope. When you light down in the hammock the rings pinch the cord and prevent it from slipping. If you need to loosen one end of the hammock you just separate the rings and the cord slides out from between them.
Advantages of this system:
- You don’t need to modify the hammock at all, the standard long cord works well. My hammock cord was worn out though, so I did need to replace it with the purple one shown.
- Easy tensioning
- Light weight
Downsides:
- The descending rings are expensive ($3 each, you need 4) and you need a tent stake or something else as the spike.
- Two knots to learn, but both are much simpler than the knot that Hennessey uses.
Andre’s system is even simpler. He cut the cord off of his hammock and replaced it with a cam-lock buckle. He carries much longer lengths of webbing. You wrap the webbing once or twice around the tree, then thread it through the cam-lock buckle. It is easy to adjust the tension. There is nothing else to it. He used low-stretch polypro webbing.
Advantages:
- Pretty inexpensive (cambuckles are cheap, 30′ of webbing is more money).
- No knots!
Disadvantages:
- Webbing is bulkier and heavier to carry than cord. My solution requires carrying about 8′ of webbing (for the two tree huggers). His solution requires carrying about 30′ of webbing.
We weren’t clever enough to invent these systems on our own. There is a 20 minute video on Youtube that goes into both and some other options:
HammockForums has days worth of reading on the subject too,and this is a good summary of some other options.